Deep Set Ground Anchor

Deep Set Ground Anchor:

Installation Instructions:

1. Confirm soil classification using standard torque probe at 36" below ground surface, make certain readings meet or exceed 350 in Ibs. (Class 2 and 3 soils) at the depths of 12" & 36". 

2. Clear loose vegetation where ground anchor will be installed. Install ground anchor verically to its' full depth. Stabilizer plate at the top of anchor must be fully embedded into soil.

3. Pull strap past anchor head and cut strap so that there is 12" to 15" of strap to wrap onto anchor bolt insuring 4 to 5 wraps minimum.

4. Insert strap into gound anchor bolt flush with opposite side of bolt. Tighten bolt/ strap until tight. Secure anchor bolt with nut.