Socket Type Disc Buckle Scaffolding Manufacturer

The assembly and disassembly speed is fast, and the amount of steel used for scaffolding can be reduced by 33%, the work efficiency of assembly and disassembly can be increased by more than two times, the construction cost can be significantly reduced, and the construction site is civilized and tidy. The sweeping pole is missing, the vertical and horizontal junctions are not connected, the distance between the sweeping pole and the ground is too large or too small, etc.; the scaffold board is cracked, the thickness is not enough, and the overlap does not meet the requirements of the specification; there is no protection between the inner pole and the wall after the large formwork is removed Falling net; the scissors support is not continuous in the plane; the open scaffolding is not equipped with diagonal braces; the spacing of the small crossbars under the scaffolding board is too large; the wall parts are not rigidly connected inside and outside; the distance between the protective railings is greater than 600mm; the fasteners are not connected tightly, Fastener slippage, etc. (1) Local deformation of the scaffold caused by the settlement of the foundation. Erection or scissor support is erected on the transverse section of the double-breasted frame, and a set of vertical rods are erected in a row until the deformation zone is outside. The foot of the scissor or scissor must be set on a solid and reliable foundation. (2) The deflection and deformation of the cantilever steel beam on which the scaffold is rooted exceeds the specified value, and the anchor point behind the cantilever steel beam should be reinforced.

Disc scaffolding is a new type of scaffolding, which was introduced from Europe in the 1980s and is an upgraded product after the bowl-buckle scaffolding. Also known as chrysanthemum disc scaffolding system, disc scaffolding system, scaffolding system, buckle disc scaffolding, layher frame (layer frame, real frame, because the basic principle of the scaffolding was invented by the German LAYHER company, It is also called "Rhea" by industry insiders. It is mainly used for lighting stands and background stands for large-scale concerts. Disc-type multifunctional scaffolding is an upgraded product after bowl-buckle scaffolding. The socket of this scaffolding is A disc with a diameter of 133mm and a thickness of 10mm. There are 8 holes on the disc. φ48*3.5mm, Q345B steel pipe is used as the main component. The pole is welded with a disc every 0.60m on a certain length of steel pipe. Novel and beautiful disc connecting bar, with connecting sleeve at the bottom.

Construction equipment with multiple functions such as cantilever frame. It can also be used to build facilities such as sheds, material sheds, lighthouses and other structures. It is especially suitable for erecting curved scaffolding and heavy-duty support frame. High efficiency: The middle length of commonly used rods is 3130mm, and the weight is 17.07kg. The assembly and disassembly speed of the whole frame is 3 to 5 times faster than the conventional one. The assembly and disassembly are quick and labor-saving. Workers can complete all the work with a hammer, avoiding many inconveniences caused by bolt operation. Strong versatility: The main components are all steel pipes of ordinary fastener steel scaffolding, which can be connected with ordinary steel pipes with fasteners, which has strong versatility. Large bearing capacity: the vertical rod connection is a coaxial socket, the cross rod and the vertical rod are connected by a bowl buckle joint, and the joint has reliable mechanical properties of bending, shear and torsion resistance. Moreover, the axis of each rod intersects at a point, and the node is in the plane of the frame, so the structure is stable and reliable, and the bearing capacity is large. (The load-bearing capacity of the whole frame is improved, which is more than 15% higher than that of the fastener-type steel pipe scaffold in the same clean condition. It is safe and reliable: when the joint is designed.