Design And Installation Of Ground Anchors

The anchor is buried in the ground, and it attaches to the film line or film belt on the greenhouse, so that it can withstand the attack of the wind. To use the technical term, it is the wind load coefficient problem. Ground anchor is also one of the wind load coefficients to enhance the foundation of greenhouses, especially the spring and autumn greenhouses and sunlight greenhouses, because of their relatively simple foundation design, it is very easy to be blown away by greenhouses. In order to ensure that the greenhouses are more robust and durable, the ground anchor is used to fix the overall structure of the greenhouses, so that the greenhouses have sufficient pulling power. In this way, the overall or partial damage to the greenhouse can be avoided due to strong winds.

The key is to look at the depth and width of the pit. The design length of the anchor is 70 centimeters, the depth of the pit should reach 55-60 centimeters, and the width should be about 24 centimeters, not too wide. Since two red bricks are placed under the anchor, it measures 24 centimeters. From the design Angle just down the width of the red brick is the most appropriate, but in the design of the excavation can not be so accurate, basically keep within 30 centimeters of the width, it is not a problem to bear the tension.